You need GNU make. On HP-UX, you also need GNU sed.
Known to work with:
- - Linux/x86, gcc-2.95.x, gcc-3.0(pre)
- - Linux/ia64, gcc-2.96, gcc-3.0(pre)
- - Linux/arm, gcc-2.95.3
- - Linux/sparc, gcc-2.95.3
- - Linux/alpha, gcc-2.95.x
- - Linux/powerpc, gcc-2.95.x
- - Solaris 2.4 (sparc), gcc-2.95
- - OSF/1 V4.0 (alpha), gcc-2.95
- - Irix 6.5, gcc-2.95.x
+ - Linux/x86, gcc-3.x, gcc-4.0.x, gcc-4.1.[0-1]
+ - Linux/x86_64, gcc-3.[3-4], gcc-4.0.x, gcc-4.1.[0-1]
+ - Linux/ia64, gcc-3.[2-4], gcc-4.0.x, gcc-4.1.[0-1]
+ - Linux/arm, gcc-3.[0-3], gcc-4.0.x, gcc-4.1.[0-1]
+ - Linux/mips, gcc-3.3, gcc-4.0.x, gcc-4.1.[0-1]
+ - Linux/sparc, gcc-3.[1-3], gcc-4.0.x, gcc-4.1.[0-1]
+ - Linux/alpha, gcc-3.[0-3], gcc-4.0.x, gcc-4.1.[0-1]
+ - Linux/powerpc, gcc-3.[0-3], gcc-4.0.x, gcc-4.1.[0-1]
+ - Solaris 2.4 (sparc), gcc-3.[1-3]
+ - OSF/1 V4.0 (alpha), gcc-3.1
+ - Irix 6.5, gcc-3.0
- BeOS, gcc-2.95.x
-The "make" step takes about 1 hour, on a P-II / 400 MHz / 64 MB.
+The "make" step takes about 30 minutes, on a P-III / 1 GHz / 512 MB.
-If you use g++ gcc-2.95.x or gcc-3.0, I recommend adding "-fno-exceptions"
-to the CXXFLAGS. This will likely generate better code.
-
-If you use g++ from gcc-2.95.x on Sparc, add either "-O", "-O1" or
+If you use g++ from gcc-3.0.4 or older on Sparc, add either "-O", "-O1" or
"-O2 -fno-schedule-insns" to the CXXFLAGS. With full "-O2", g++ miscompiles
-the division routines. If you use g++ older than 2.95.3 on Sparc you should
-also specify --disable-shared because of bad code produced in the shared
-library. Also, on OSF/1 or Tru64 using gcc-2.95.x, you should specify
---disable-shared because of linker problems with duplicate symbols in shared
-libraries.
+the division routines. Do not use gcc-3.0 on Sparc for compiling CLN, it
+won't work at all.
More detailed installation instructions can be found in the documentation,
in the doc/ directory.